XRF-2000 Series Operating Manual
10
2. System Operation
2.1 Safety Considerations
Standard Procedures
All standard safety procedures for operating electrical machinery should
apply to spectrometers of this series.
Each system is intended to be operated only as indicated in its Operation
Manual.
Maintenance work inside the machine should be performed only by
authorized personnel.
Power Source
This product is intended to operate from a power source that does not
supply more than 230 volts RMS (in 220 volt version) or 120 volts RMS
(in 115 volt version) between either supply conductors or between supply
conductor and ground. A protective ground connection by way of the
grounding conductor in the power cord is essential for safe operation.
Grounding the Product
This product is grounded through the grounding conductor of the power
cord. To avoid electrical shock, plug the power cord into a properly wired
receptacle before connecting to the product input or output terminals. A
protective ground connection by way of grounding conductor in the
power cord is essential for safe operation.
Danger arising from loss of Ground
Upon loss of the protective ground, all accessible conductive parts
(including knobs and controls that may appear to be insulated) can
render an electric shock.
Use the proper power cord
Use only the power cord and connector specified for your product and
valid in the country where the machine in installed. Make sure that both
are in good condition and do not use extension cables.
Use the proper fuse
To avoid fire hazard, use only a fuse of the correct type, voltage rating
and current rating as specified.