Microtest 8740 - Page 58

57
(3) Single node
Set whether to test for empty pins; it is mainly used to test tests with no circuits.
(4) DC arc Sens
Set the DC arc detection sensitivity; the lower the value the more sensitive it is, the higher the value the
less sensitive it is.
(5) AC arc Sens
Set the AC arc detection sensitivity; the lower the value the more sensitive it is, the higher the value the
less sensitive it is.
(6) A (B, C, D, E, F, G, H) PORT MaxPin (Alnet
Set the final pin of A (B, C, D, E, F, G, H) PORT.