Miele G2000 - Page 118

Technical Information
118
G1000 / G2000 Dishwashers
Flashing
Rhythm of
Intake/Drain
Lt.
Flashing Rhythm of
SaniWash LED
Function Programming Indication
Long Short Long Short Display
- -
Pos. 0:
Software
version ID
check
Do not press the
Program button.
The Intake/Drain
LED is off.
The Sani-Wash
LED is off or
flashes. Shows the
software version ID
No., e.g. -769
- - ID No.
Long Short Long Short Display
Press the Program
button 1x.
The Intake/Drain
LED flashes 1x
briefly
intermittently. With
this programming
function, all
parameters can be
reset to delivery
condition.
- -
P0
Pos. 1:
Reset
If the To reset all
parameters to the
delivery condition,
press the Program
button and hold
until the
Intake/Drain LED
flashes. Then press
the Program button
briefly *2
- 1
SaniWash LED is
off, the values do
not correspond to
the delivery
condition. If the
SaniWash LED
flashes, all values
are as in the
delivery condition.
- 1 P1
Long Short gr/gal
- 1 1-5
Press the Program
button 2x.
- 2 6-9
- 3 10-14
- 4 15-19
- 5 20-25
- 6 26-31
- 7 33-38
- 8 39-45
- 9 46-63
- 2
Pos. 2: Set
the water
hardness
To modify the water
hardness setting,
press the Program
button to enter the
desired setting
changes. *2
The Intake/Drain
LED flashes 2x
briefly
intermittently.
The current setting
can be seen from
the flashing rhythm
of the SaniWash
LED. If the LED
flashes 4x briefly
intermittently, this
indicates a factory
setting of 15-19
gr/gal.
1 - 64-88
Table 6-9: G2170 Programming Mode Options (continued on Table 6-10)