Miele G2000 - Page 119

Technical Information
G1000 / G2000 Dishwashers
Flashing
Rhythm of
Intake/Drain
Lt.
Function Programming Indication
Flashing Rhythm of
SaniWash LED
Long Short Long Short Display
- - 0 ml
- 1 1 ml
- 2 2 ml
- 3 3 ml
- 4 4 ml
- 5 5 ml
- 3
Pos 3: Set
amount of
rinse aid
dispensed
Press the Program
button 3 times.
To modify the
dispensing amount,
press the Program
button and hold it
until the
Intake/Drain LED
flashes. Then use
the Program button
to enter the desired
setting changes. *2
The Intake/Drain
LED flashes 3x
rapidly
intermittently.
The current setting
can be seen from
the flashing rhythm
of the SaniWash
LED. If he LED
flashes 3x briefly
intermittently, this
indicates a factory
setting of 3ml.
Setting range: 0-6
ml.
- 6 6 ml
- - P0
- 4
Pos 4:
Buzzer
on/off
Press the Program
button 4x
To change the
setting, press the
Program button
and hold it until the
Intake/Drain LED
flashes. Then press
the Program button
to enter the desired
setting changes. *2
The Intake/Drain
LED flashes 4x
rapidly
intermittently.
SaniWash LED off
= Buzzer is
actuvated (factory
setting). SaniWash
LED flashes =
Buzzer is
deactivated.
- 1 P1
Table 6-10: G2170 Programming Mode Options (Cont. from Table 6-9) (Cont. on Table 6-11).
119