Technical Information
164
G1000 / G2000 Dishwashers
Flashing
Rhythm of
Gel LED
Function Programming Display
Flashing Rhythm of
Sani-Wash LED
Long Short Long Short Display
- - P0
- 4
Pos 4:
Buzzer
on/off
Press the Gel
button 4 times. The
Gel LED flashes 4
times rapidly
intermittently. Press
the program button
as appropriate to
make the desired
setting.
The display shows
P and a digit
alternately: P0 =
Buzzer off; P1 =
Buzzer on.
- 1 P1
Long Short Long Short Display
- - P0
- 5
Pos. 5:
Sensor
wash
program
modification
(from
software
version ID
No. 984)
Press the Gel
button 5 times. The
Gel LED flashes 5
times rapidly
intermittently. Press
the program button
as appropriate to
make the desired
setting.
The display shows
P and a digit
alternately: P0 =
Normal program
sequence (standard
setting); P1 =
Modified program
sequence. This is
used to adjust the
Sensor wash
program
parameters so it
can be used to
wash items with
stubborn stains
even if the overall
level of soiling is
otherwise low.
- 1 P1
Long Short Long Short Display
- - P0
1 2
Pos. 12:
Resetting
standard
settings *2
Press the Gel
button 12 times.
The Gel LED
flashes once slowly
and 2 times rapidly
intermittently. Press
the program button
to reset all standard
settings.
The display shows
P and a digit
alternately: P0 =
Normal program
sequence (standard
setting); P1 =
Modified program
sequence. This is
used to adjust the
Sensor wash
program
parameters so it
can be used to
wash items with
stubborn stains
even if the overall
level of soiling is
otherwise low.
- 1 P1
Table 6-39: G1470 / G2470 Programming Mode Options (Cont. from Table 6-38) (Cont. on Table 6-40)
To Next Page
Loading...
