To Next PageTo Next Page
Need help?Do you have a question about the Mighty Mule TS571W and is the answer not in the manual?
Details different classes of vehicular gate operators for specific applications.
Procedures for safely disconnecting the operator and manually moving the gate.
Key considerations and checks before starting the gate operator installation.
Critical safety steps and guidelines to follow while installing the gate operator.
Post-installation safety checks and responsibilities for the gate operator.
Guidelines for placing warning signs and ensuring separate pedestrian access.
Specifies warning labels and their placement for gate safety.
Details about the operator's drive mechanism, motor, and opening arc.
Information on power sources, battery, transformer, and solar panel requirements.
Describes the control board, transmitter technology, and programmable features.
Table showing maximum gate weight and length supported by the operator.
Guidance on choosing between transformer or solar power for the gate operator battery.
Illustrates solar panel ratings and gate cycle expectations based on geographic zones.
Essential checks for gate condition, swing, hinges, and mounting stability before installation.
Instructions and recommendations for grounding the gate operator system.
Lists the necessary tools for installing the gate operator.
Lists components and materials that must be purchased separately for installation.
Guidance on determining the gate's swing direction for proper operator mounting.
Steps to evaluate the gate's suitability and condition for operator mounting.
Methods for reinforcing gate structures to properly mount the operator brackets.
Detailed instructions for mounting the operator for a pull-to-open gate configuration.
Guide for installing the stop plate to define the gate's closed position in pull-to-open setups.
Detailed instructions for mounting the operator for a push-to-open gate configuration.
Guide for installing the stop plate to define the gate's closed position in push-to-open setups.
Configuration options for push/pull operation, system power, and movement alarm.
Procedures for programming and erasing transmitters.
Setting the closed limit for pull-to-open gate configurations.
Setting the open limit for push-to-open gate configurations.
Adjusting the force sensitivity for the gate operator's obstruction detection.
Configuring the automatic gate closing timer.
Guide for routing accessory wires through the control box wiring knockout.
Detailed explanation of control board terminals for accessory inputs and outputs.
Guides for installing specific optional accessories like FM130-SW and FM136 keypad.
Step-by-step guide for installing the FM130-SW transmitter module.
Steps to program the FM136 keypad as an additional transmitter for the gate operator.
General| Gate Type | Swing |
|---|---|
| Gate Weight Capacity | 850 lbs |
| Remote Control | Yes |
| Smartphone Control | Yes |
| Smart Control | Yes |
| Number of Remotes Included | 2 |
| Gate Length Capacity | 18 ft |
| Battery Backup | Yes |
| Connectivity | WiFi |
| Voltage | 12V |
| Opening Speed | Approximately 16 seconds to open |
| Safety Features | obstruction sensing |
| Power Source | AC or Battery |
