19
Technical Data
Working temperature range 0 °C to +40 °C
32 °F to 104 °F
Current consumption Standby 190 µA
Normal 280 mA
Maximum 1,200 mA
Weight 880 g
Working temperature range -5 °C to +45 °C
23 °F to 113 °F
Current consumption Receive max. 70 mA
Transmit max. 80 mA
Supply voltage 3.5 to 8.4 V (2S LiPo)
Weight 8 g
Working temperature range -5 °C to +60 °C
23 °F to 140 °F
Current consumption ca. 120 mA
Supply voltage 3.5 to 8.4 V (2S LiPo)
Working temperature range 0 °C to +50 °C
32 °F to 122 °F
Current consumption ca. 80 mA
Supply voltage 3.5 to 8.4 V (2S LiPo)
Care and Cleaning
☝ Attention Use a soft brush to remove dirt and sand from
surfaces and from the gimbals, to avoid scratches.
☝ Attention Use a dry or damp microber or other soft cloth to
clean the surfaces. Do not rub rmly. Only neutral detergent
may be used (check on a hidden surface rst if in doubt).
☝ Attention Take special care when cleaning the display, for-
eign parts like dirt or sand for example might scratch the
surface even when a soft cloth is used.
☝ Attention Do not use dripping wet cloth, and do not use hot
water, benzine, gasoline, model fuels, thinner or other vol-
atile detergents for example, as they might permanently
damage or mark surfaces or damage the electronics inside.
Getting Support and
Service for your VBar
Control
Mikado Model Helicopters offer free warranty repair or re-
placement during the legal warranty period applicable only
if VBar Control is faulty during or after use according to the
specication and this manual, and based on the regula-
tions of Mikado Model Helicopters.
Mikado Model Helicopters will charge cost for repairs or
replacements necessary e.g. because of improper use, af-
ter the warranty period, and without proof of purchase pro-
vided.
Warranty will be limited to the VBar Control itself and does
not cover other components on the model like servos,
power units, the model itself and especially non-Mikado
products.
Mikado Model Helicopters do not take responsibility for
any physical damage or physical injury as well as loss of
use or data saved on the device or any similar claim.
After the warranty period has expired, or in case the dam-
age was not a warranty issue, Mikado Model Helicopters
will repair VBar Control with costs. We will provide a repair
estimate to the customer.
Repairs will only be made if VBar Control can be used
safely again in the future.
Please note that costs of some repairs might exceed the
value of the device and might not be economically sensible.
☝ Attention Legal warranty periods may differ depending on
the laws applicable in the country you live in. Please ask
your local dealer/distributor for further details.
☝ Attention Make sure you save the les on your VBar Con-
trol to your computer before you send it in for warranty or
general repair. The device may be reset and re-installed at
the service shop, causing loss of all data saved on the in-
ternal memory.
Mikado Model Helicopters provides extensive worldwide
after-sales service on the forums at the support web site
www.vstabi.info as well as via e-mail through service@mi-
kado-heli.de.
Spare parts and accessories for your VBar Control are
available at www.mikado-heli.de.
To Next Page
Loading...
Need help?
General
