31
,
,
from the
menu.
☠ Danger Take safety precautions so the power unit can not
start up accidentally and cause physical injury or physical
damage.
Select
from the menu.
Carefully read the instructions of your ESC and the instruc-
tions on the screen of your VBar Control Transmitter. Your
heli and the VBar Flybarless Controller must be set up us-
ing the wizard. Both must be wired properly according to
the manuals prior to entering this menu.
To start with the ESC programming wizard, move the col-
lective stick to full negative. The screen will change so you
can start the actual setup.
See the manual of the ESC for understanding the required
setup procedure.
To enter the programming mode of the ESC, cut power to
your VBar Flybarless Controller, and wait for the current
screen to disappear. Now turn on your VBar Flybarless
Controller again.
Your VBar Control transmitter and the VBar Flybarless
Controller are in a programming mode now, which allows
you to program the ESC using the collective stick, as if it
was connected to a regular receiver.
Once nished with the programming, press Exit, and pow-
er-cycle your VBar Flybarless Controller again for the ESC
to start up in regular mode again.
☝ Attention If it is required that you program each feature of
your ESC individually, just go through the ESC Setup Wiz-
ard again for each required step in the ESC setup manual.
To Next Page
Loading...
Need help?
General
