30
,
,
from the
menu.
☠ Danger Take safety precautions so the power unit can not
start up accidentally and cause physical injury or physical
damage.
Select
from the menu.
Carefully read the instructions of your Kontronik ESC and
the instructions on the screen of your VBar Control Trans-
mitter. Your heli and the VBar Flybarless Controller must
be set up using the wizard. Both must be wired properly
according to the manuals prior to entering this menu.
Move the collective stick to full negative to start with the
ESC programming wizard. The screen will change so you
can start the actual setup.
Plug in the programming jumper of the Kontronik ESC. To
enter the programming mode of the ESC, cut power to
your VBar Flybarless Controller, wait for the current screen
to disappear. Now turn on your VBar Flybarless Controller
again.
Your VBar Control transmitter and the VBar Flybarless
Controller are in a programming mode now, which allows
you to program the ESC using the collective stick, as if it
was connected to a regular receiver.
Now follow the Kontronik programming procedure. Re-
move the programming jumper, wait for the ESC to con-
rm. Now wait for the ESC to indicate ‘Mode 4’ with four
consecutive beeps, and conrm with moving the collective
stick to full positive. The ESC will conrm again.
Now press Exit, and power-cycle your VBar Flybarless
Controller again for the ESC to start up in regular mode
again.
☝ Attenteion If you want to program further features of your
Kontronik ESC, just go through the ESC Setup Wizard
again. At the last step, just wait for the ESC to indicate the
desired mode (e.g. 9 consecutive beeps for LiPo mode, 10
consecutive beeps for KSA mode, 11 consecutive beeps for
constant rpm control mode).
To Next Page
Loading...
Need help?
General
