Miller Continuum - SECTION 5 - INSTALLATION; 5-1. Power Source And Wire Feeder Site Selection

OM-266409 Page 13
SECTION 5 − INSTALLATION
! Special installation may be required
where gasoline or volatile liquids are
present − see NEC Article 511 or CEC
Section 20.
! Do not move or operate equipment
where it could tip.
1 Hand Cart
Use cart or similar device to move unit.
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Line Disconnect Device
Locate unit near correct input power supply.
5-1. Power Source And Wire Feeder Site Selection
3
18 in.
(460 mm)
18 in.
(460 mm)
1
Movement
Location And Airflow
2
OR
! Do not move or operate
unit where it could tip.
! Do not put feeder where
welding wire hits cylinder.
Loc_contfeeder 2015-07