MIMAC SUPREMA PLUS - 2. Preliminary Information (Continued); User Training Requirements; Terms of Use; Intended Use Guidelines

8
www.mimac.com
2.9. USERS TRAINING
The machine was designed and manufactured for professional use. Those who use the machine must be trained in
order to become familiar with:
 all the functions of the control panel;
 all the installed protection guards and safety systems;
 commissioning and putting out of service;
 the possible work cycles;
 the various machine stop devices, including the emergency stops;
 loading the material to be processed;
 unloading the processed material;
 the contents of this Manual;
 the checks to be carried out periodically;
 all the routine maintenance operations.
Operators must also avoid doing anything on their own initiative; they do not have to carry out any interventions that
are outside their competence and technical knowledge
If something wrong occurs the operators have to:
 intervene immediately and stop the machine, using the emergency push-button;
 immediately inform their supervisor, and request his timely presence.
When the training phase is completed, operators must undergo an evaluation test on their acquired level of
awareness. The training phase and the result of the aptitude test must be documented within the company.
The machine must not be used by people who have not been declared legally suitable for
handling food products.
2.10. TERMS OF USE
Permitted environmental values for good machine operation:
 temperature from +5 °C to +40 °C with an average not exceeding 35 °C over 24 hours;
 relative humidity between 30% and 95% (without condensation);
 absence of ionising and non-ionising radiation.
The environment around the machine must be kept clean. Remove the plug from the mains before moving the
machine for cleaning.
The workplace lightning must:
 guarantee good visibility at every point;
 not create dangerous reflections;
 allow for the control panel and the emergency push-buttons to be read clearly.
2.11. INTENDED USE
MIMAC ITALIA is not liable for any injury caused to people or damage to things arising from any unauthorised
changes made to the original operation software granted in use to the Customer.
It is forbidden to use the machine in conditions or for purposes other than those indicated in the manual and MIMAC
ITALIA cannot be held responsible for faults or accidents caused by the non-observance of this rule.
Do not use the machine if the safety devices have been tampered with: before starting to work, the operator must
make sure that the safety devices, such as the emergency push-button and the micro-switches connected to the
mobile guards, are working correctly.
Do not hit the safety guards or place weights on them: even though the machine has solid guards, these are not
suitable for holding heavy weights or being hit hard.
Machine must not be used by unskilled users: this manual must be read carefully before starting to work with the
machine.
Do not direct jets of water directly towards the machine, especially towards the guards and the electrical and
electronic parts, while washing the machine and the workplace.
The Manufacturer is not liable for damage if one of the following conditions occurs:
 incorrect installation;
 power supply faults;
 failure to comply with the instructions;
 incorrect machine use or machine used by unskilled users;
 using the machine in a manner that is not indicated in national regulations;
 negligent maintenance operations;
 unauthorised modifications or interventions;
 using spare parts that are not original or not specific for the model.