MIMAC SUPREMA PLUS - 2. Preliminary Information (Continued); Workplace Preparation; Machine Receipt and Handling

USE AND MAINTENANCE MANUAL
7
The software cannot be altered, modified, copied and/or reproduced without written authorisation from MIMAC
ITALIA.
Being the owner of the software used to run its machines, MIMAC ITALIA will not grant the source codes of its
software for any reason and will persecute anyone or anything that copies, reproduces, decodes or modifies the
same software.
2.7. PREPARATION OF THE WORK PLACES
Unless otherwise indicated in the contract, the following must be carried out by the Customer:
 preparation of the areas, including any building works and/or piping and conduit that are required;
 the power supply for the machine, in compliance with the laws in force in the user’s country.
The installation area of the machine, being meant for production of oven-baked products, must have:
 openings that allow the bulkiest parts of the machine to pass;
 construction features that are in compliance with current standards;
 an electric system that is in compliance with current standards; special care must be taken with the earthing
system and the main panel, which must have relative protection devices against overloads and short circuits.
The nominal power installed on the machine is indicated on the identification plate.
The complete electric system must be realized and kept periodically under control by professionally trained
technicians who can accompany each intervention with a declaration of conformity to “the rules of the trade”.
2.8. RECEIVING THE MACHINE
The Manufacturer is not liable for any accident, damage or machine fault that may occur if the
indications that follow are not observed.
Make sure no damage occurred during transport and that the packaging is whole. If this is not the case, inform the
shipping agent and write “Accepted with a reservation” on the shipping document.
If any damage is caused during transport, the shipping company must be informed by the Customer, in writing
within 8 days from receipt of the goods. Inform the Manufacturer immediately if serious damage has occurred.
Make sure the goods correspond to the items listed in the shipping document. Inform the Manufacturer immediately
if pieces are missing.
2.8.1. PACKAGING
The machine and its accessories can be delivered:
 without packaging, fixed to the loading surface, only protected by an outer film to prevent scratches;
 by container or in palletized wooden crates.
If transported by sea, the machine is inserted inside a sealed wrapping to protect it from atmospheric agents.
2.8.2. LIFTING AND HANDLING
All operations must be carried out by people who have been authorised and under the
supervision of a person in charge.
Operators must wear all the personal protection equipment necessary for the operations to
be carried out safely and must use suitable tools.
Before starting operations, identify and make sure there are no danger points in the movement area, including the
area where the means of transport is positioned and the installation area.
The transport and lifting means must be suitable for the weight to be lifted. Concerning this, read the weights printed
on the packaging and/or indicated in this manual.
Inspect the cables before using them to make sure there is no damage or signs of wear. Do not twist or knot the
cables and follow the Manufacturer’s instructions; these instructions are valid also for chains or belts.
Be careful when positioning the lifting or slinging systems; make sure the load is perfectly balanced before lifting it.
It is forbidden to get onto the load, or to move and/or remain under it while it is being moved.
It is forbidden, for those people who are not involved in transporting and moving, to access the relative areas.
All operators must remain at a safety distance from the packages when they are lifted from the ground to avoid
being hit if they fall.
Do not allow the load to oscillate during lifting.
Lift the machine using a fork-lift, inserting the forks under the lower surface at the baricentre point
Position the machine on a solid and even floor/worktop.
2.8.3. UNPACKING
When installation has been completed, all the packaging material must be disposed of in compliance with the
national regulations in force.
The equipment and material used for lifting should be positioned in a suitable place and stored carefully for possible
machine transfer.