3. SAFETY
3.1. GENERAL INFORMATION
The machine was designed to work safely. All commands are given using a touchscreen panel and the push-button
present on the control panel.
The emergency push-button inhibits all machine functions; to reset them release the emergency push-button and
press the re-establishment push-button. No component will start moving before the emergency push-button is
released.
The stability of the whole machine is sufficient to guarantee use in the indicated operating conditions without risks of
overturning, falling or moving unexpectedly.
Do not tamper with or eliminate the safety devices that are installed on the machine.
Periodically check the effectiveness of the safety systems.
Do not damage or eliminate the safety signals that are applied to the machine; if a safety signal is damaged or
missing, immediately inform the person in charge of company safety and ask for its replacement.
If operators tamper with the safety devices, the Manufacturer is not liable for any resulting injury to people or
damage to things. The operator becomes the only person responsible when facing competent bodies.
If danger arises for people or things, press the emergency push-button.
3.2. DESCRIPTION OF PICTOGRAMS
ATTENTION! Machine moving parts in action
DO NOT remove safety devices
DO NOT clean, grease or adjust the machine elements
while they are in action
DO NOT clean the machine using water jets
ATTENTION! Hand crush hazard
To Next Page
Loading...
