Safety Precautions
ix
Cautions on Installation
Handling of media
• Use media recommended by MIMAKI to ensure reliable,
high-quality printing.
• Set the heater temperature to meet the characteristics of the
media. (Model with a built-in heater)
Set the temperature of the Pre-heater, Print heater and Post-
heater according to the type and characteristics of the media
used. Automatic temperature setting can be made on the
operation panel by setting the profile on the dedicated RIP.
For setting on the RIP, refer to the instruction manual for
your RIP.
• Pay attention to the expansion and contraction of the media.
Do not use media immediately after unpacking. The media
can be affected by the room temperature and humidity, and
thus it may expand and contract.The media have to be left in
the atmosphere in which they are to be used for 30 minutes
or more after unpacked.
• Do not use curled media.
The use of curled media can not only cause a media jam but
also affect print quality.
Straighten the sheet of media, if significantly curled, before
using it for printing. If a regular-sized coated sheet of media
is rolled and stored, the coated side has to face outside.
• Do not leave the media with the heater ON for a long time.
Protection of media from dust
• Store media in a bag. Wiping off dust accumulated on media
will adversely affect the media due to static electricity.
• When leaving the workshop after the working hours, do not
leave any media on the roll hanger. If any media is left on the
roll hanger, it can get dusty.
Protection of media from dust
• Store media in a bag. Wiping off dust accumulated on media
will adversely affect the media due to static electricity.
• When leaving the workshop after the working hours, do not
leave any media on the roll hanger. If any media is left on the
roll hanger, it can get dusty.
Periodic replacement parts
• Some parts of this machine must be replaced with a new
one periodically by service personnel. Be sure to make a
contract with your distributor or dealer for After sale service
to ensure a long life of your machine.
Warning
CAUTION
A place exposed to direct
sunlight
On an inclined surface
A place that vibrates
A place exposed to direct air
flow from an air conditioner
or the like.
A place where temperature or
humidity varies significantly
Around a place where fire
is used
• Use the machine under the
following environmental
conditions:
• Operating environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)
To Next Page
Loading...
