Chapter 2 Basic Operation
2-8
Take-up device
With the switch of the narrow take-up device, select the
take-up direction of the media or others.
Setting the torque limiter
The take-up device is provided with a torque limiter.
The take-up torque can be adjusted with the torque limiter.
(The torque limiter is set to "Medium" at delivery.)
If the tension is too strong to use a thin sheet of media,
lower the take-up torque with the torque limiter.
Clockwise turn :
Increases torque (a heavy and thicker media such as
tarpaulin or the like)
Counterclockwise turn :
Decreases torque (For light media)
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover, and raise the clamp
lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• When the torque limiter is adjusted too weak ;
The media can not be taken up firmly.
•
When the torque limiter is adjusted too strong ;
The slack may occur depending on the media and
cause influence on the image quality.
To Next Page
Loading...
