Chapter 2 Basic Operation
2-14
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-4)
2
Press the
(REMOTE)
key in LOCAL.
• The screen changes to REMOTE, and data can
be received from the PC.
3
Transmit data to be printed from the PC.
• The ACTIVE lamp blinks and the printing
conditions are displayed.
• For the method of data transmission, see the
instruction manual for the output software.
4
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.
Stopping a Printing Operation
Perform the following operation when stopping a printing
operation halfway.
1
Press the
(LOCAL)
during printing.
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already
received data.
1
Press the key, and press the
(DATA CLEAR)
in LOCAL.
2
Press the key.
• The received data is erased then it returns to the
Local.
Cutting a media
By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press .
• It enters into the origin setting mode.
• By pressing [] , feed the media to the cutting
position.
2
Press the key.
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.
• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
To Next Page
Loading...
