Chapter 4 Maintenance
4-15
1
2
2
4
5
6
Replacing consumables
Replacing the wiper
The wiper is consumable. When the display indicates the
warning message “Replace a WIPER” it is necessary to
check and replace the wiper, immediately replace the
wiper with a new one.
Also, wipe ink sticking to the lower surface of the slider off.
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key.
• “STATION” will be selected.
3
Press 4 times, and press the
key.
• “WIPER EXCHANGE” will be selected and the
number of times the wiper was used will be reset.
4
Press the key.
• The carriage will move onto the platen.
.
5
Remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
6
Insert a new wiper.
• Insert the wiper by holding the protrusions at its
both ends.
7
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
LOCAL.
• When the warning message for replacing wiper is
shown, confirm whether there is no damage and
fuzz at the top edge of the wiper film. If there is no
damage on the top edge of the wiper film, it is
possible to use the wiper continuously without
replacing it.
• A cleaning wiper is an option.Buy one through the
dealer in your region or at our service office.
To Next Page
Loading...
