MIMAKI JV150-130 - Setting a roll media

2-5
2
2
2
5
6
Chapter 2 Basic Operation
Setting a roll media
Set a roll media to the roll media hanger located on the
back of this machine.
1
Move the roll holder located in the back of
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and then move
it.
2
Check the clamp lever is lowered.
3
Move the roll holder to the roll setting
position.
• Check the roll stopper is not caught between the
roll stopper arm and this machine.
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll media
on the left roll holder.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
6
Loosen the screw of the right side roll
holder then insert the holder into the core
of the roll media.
7
Raise the clamp lever in the rear of this
machine.
Lock screw
Roll holder
Roll holder
Base
Roll Holder Side (The back of this machine)
Setting position
of 2inch tube
Setting position
of 3inch tube
Set the base position of roll holder
within this range.
• There are two types of the internal diameter of the
roll media paper tube: 2 inch and 3 inch.