3-8
Chapter 3 Setup
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press the
(>>)
.
4
Press to select “Margin/L” or
“Margin/R”, and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST / -10 to 85 mm
6
Press the key several times
to end the setting.
Setting of VacuumFan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press the
(>>)
.
4
Press to select “VACUUM FAN”,
and press the key.
5
Press the key.
6
Press to select a set value, and
press the key.
• Set value : HOST/WEAK /STANDARD/ STRONG
7
Press the key several times
to end the setting.
Setting of Feed Speed
Changes the media feeding speed in printing.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press the
(>>)
.
4
Press to select ““FEED
SPEED”, and press the key.
5
Press the key.
6
Press to select a set value, and
press the key.
• Set value : HOST / 10 to 200%
7
Press the key several times
to end the setting.
• When you give priority to the setting at the RIP
software side, make the setting value “Host”.
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to “Host”,
printing will be performed in “Margins for right and
left off set value= 0 mm” status.
• The margin setting is reflected when the media
width is detected.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in
printing.
To Next Page
Loading...
