3-3
1
2
3
4
5
6
Chapter 3 Setup
SETUP MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : DRYING TIME/ MARGIN (LEFT and RIGHT)/ VACUUM FAN/ FEED SPEED
• When you operate the machine according to the contents specified with the RIP software, set each
• item to “Host” when registering this machine type. When you set it other than “Host”, the machine operates according to
the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value
When no instruc-
tion from RIP
exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority to the setting value at
the machine side.
Outline
FEED COMP. ( P.3-5) -9999 to 0
to 9999
Used to print a pattern for correcting a media-
feeding rate and correct it.
DROP.POScorrect ( P.3-6) -40.0 to 0
to 40.0
Used to adjust the dot position in go and return
printing.
HEATER
(P.3-6)
PRE
OFF/ 20 to 50 °C
(OFF/ 68 to 122°F)
Sets each heater's conditions. PRINT
POST
OFF TIME NONE/ 0 to 90 min
Set the time from the print completion until the
heater to be OFF.
LOGICAL SEEK ( P.3-7)
HOST
/ON / OFF OFF Sets the scan movable area during printing.
DRYING TIME
(P.3-7)
SCAN
HOST
/0.0 to 9.9 sec 0 sec
Sets the time to wait for ink drying.
PRINT END
HOST
/0 to 120 min 0 min
MARGIN/LEFT ( P.3-8)
-10 to 85mm
0 mm
Sets a non-printing area along the right and left
edges of the media.
MARGIN/RIGHT ( P.3-8) 0 mm
VACUUM FAN ( P.3-8)
HOST/ WEAK/ STANDARD/
STRONG
STRONG
Sets the absorbability of the media.
FEED SPEED
*2
( P.3-8)
*2. When you set this to “100%” or more, required time for completion of printing will be shortened. However, enough drying time cannot be ensured and it may
affect the image quality.
10 to 100 to 200? 100 % Changes the media feeding speed in printing.
AUTO
CLEANING
(P.3-9)
OFF, FILE, LENGTH,
TIME
Sets the automatic cleaning operation for the head
performed before printing or during printing.
FILE
INTERVAL
1 to 1000
TYPE NORMAL/ SOFT/ HARD
LENGTH
INTERVAL
0.1 to100.0m
TYPE NORMAL/ SOFT/ HARD
TIME
INTERVAL
10 to 120 min
TYPE NORMAL/ SOFT/ HARD
Cleaning Check ON/ OFF
Set to run or not a nozzle check after auto
cleaning.
INTERVAL WIPING ( P.3-9) 3 to 255 min, OFF
Sets the wiping operation performed after printing
is completed.
EXTERNAL HEATER ON/OFF
Set to "ON" when use the external heater for
drying the media. For more information, please
refer to the separate manual, "Compact Relay
BOX Operation Manual".
RESET SETTING ( P.3-5) The configulation in the settings 1-4 can be reset ondividually.
To Next Page
Loading...
