MIMAKI JV150-130 - Moving This Machine; Where to Install This Machine; Working Environmental Temperature

Chapter 1 Before Use
1-2
Moving This Machine
Where to Install This Machine
Secure a suitable installation space before assembling
this machine.
The place of installation must have enough space for not
only this machine itself, but also for the printing operation.
Working Environmental Temperature
Use this machine in an environment of 20 to 30°C to
ensure reliable printing.
Moving This Machine
Move this machine according to the following steps when
this machine needs to be moved on the same step-free
floor.
1
Remove the caster blocks.
2
Move this machine as shown in the figure.
• For safety, be sure to operate it with 4 people or
more.
• Do not push the cover to move this machine since
the cover may be broken.
3
Reinstall the caster blocks.
Model Width Depth Height
Gross
weight
JV150-130 2525mm 700mm 1392mm 160kg
JV150-160 2775mm 700mm 1392mm 185kg
500 mm or more
35
25 mm
or
mor
e (
13
0 mod
el
)
377
5 mm o
r
mo
r
e (
13
0 mode
l
)
2
7
0
0
m
m
o
r
m
o
r
e
500 mm or more
1
0
0
0
m
m
o
r
m
o
r
e
1
0
0
0
m
m
o
r
m
o
r
e
• When the machine is moved to any place other
than on the same step-free floor, contact your
distributor or our service office.
If you move it by yourself, failure or damage may
occur. Be sure to request your distributor or our
service office to move this machine.
• When moving this machine, take care that it does
not receive a significant impact.
• Be sure to lock the casters after moving of this
machine.