Chapter 1 Before Use
1-8
Connecting Cables
Connecting USB2.0 Interface Cable
Connect the PC and this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
When two or more JV
150
machines are connected
to one personal computer
When two or more JV150 machines are connected to
one personal computer, the personal computer may
not recognize all the JV150 machines normally.
Reconnect the unrecognized JV150 machine to
another USB port, if available, and check to see if it is
recognized.If the JV150 machine is not recognized by
the newly connected USB port, use USB 2.0 repeater
cables available on the market.
Notes on peripheral devices in USB high speed
mode
When a peripheral device (USB memory or USB HDD)
to be operated in USB high speed mode is connected
to the same personal computer that a JV150 machine
is connected to, the USB device may not be
recognized.
When JV150 is connected to the personal computer to
which an external HDD is connected via USB, the
speed of data output to JV150 may drop.That can
cause the head unit to stop temporarily at the right or
left end during printing.
Removing USB memory
If a USB memory module is inserted in the personal
computer to which a JV150 machine is connected,
click "Stop" in the "Safely Remove Hardware" window
by following the instructions given there first and then
remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.
Connecting the power cable
1
Insert the power cable into an inlet of the
machine.
2
Secure a cable band.
• Secure the cable with the cable band attached to
this machine.
3
Insert the power plug into a plug socket.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached
to the PC.
• Your RIP must be compatible with USB 2.0.
• Do not use any power cables other than the
attached power cable.
• Be sure to connect the power cable to the outlet
near this machine, and make sure that the power
cable can be easily removed.
• Connect the power cable to the grounded
outlet.Otherwise, it may result in fire or an electric
shock.
To Next Page
Loading...
