MIMAKI JV150-130 - If a Waste Ink Tank Confirmation Message Appears

4-16
Chapter 4 Maintenance
If a Waste Ink Tank Confirmation
Message Appears
Ink used in head cleaning, etc. is stored in the waste ink
tank on the lower right side of the machine.This machine
counts the accumulated amount of discharged ink. When
that reaches a specified amount, the machine displays a
confirmation message.(When this message is displayed,
consider the replacement of the waste ink tank.)
Confirmation Message in LOCAL
1
The warning message “Check waste ink”
is displayed.
2
Check the state of the waste ink tank
• When it is different from the actual amount, press
[][] and correct.
• When you correct (80%), press the [ENTER] key
to return to LOCAL.
• When you replace (disposal) and clear the count,
perform the procedures in “Replace the waste ink
tank with another”. ( P.4-16)
Replace the waste ink tank with
another
1
The warning message “Check waste ink”
is displayed.
2
Press the
(MAINT.)
key.
3
Check the state of the waste ink tank.
4
If the amount of waste ink needs to be
adjusted, press the key.
• Compare the amount of waste ink shown on the
display and the amount you visually confirmed. If
there is no major problem with the value shown
on the display, instead of the [ENTER] key, press
the [END] key and proceed to Step 6.
5
Press to adjust the level, and
press the key.
6
Pull the waste ink tank stopper to open to
the front.
7
Pull it frontward to remove by holding the
waste ink tank handle.
• The message is displayed when it reaches 80%
(1.6L ) of the 2L tank.
• Put a cap on the waste
ink tank removed.
Waste ink tank
stopper
Waste ink
tank
Cap