Chapter5 Troubleshooting
5-8
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message Cause Solution
SDRAM is defective.
• Turn off the power to the machine and turn it
on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
Head control circuit board is defective.
The battery life end of the internal clock
is detected.
• Contact your local distributor to call for ser-
vice.
Head data transferring sequence error
occurred.
• Turn off the power to the machine and turn it
on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
Sequential number abnormality of the
event log occurred.
Error occurs in the power supply system
of the main board.
An error is detected on the waveform
printed on.
An error occurred in the main PCB .
To Next Page
Loading...
