5-9
1
2
2
2
5
6
Chapter5 Troubleshooting
An error occurred in the main PCB .
• Turn off the power to the machine and turn it
on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred in the COM16/32IO
PCB .
An error occurred in the SLIDER2H PCB
.
The machine received some data other
than print data.
Or, an error occurred in the transmitted
print data.
• Securely connect the interface cable in posi-
tion.
• Use an interface cable conforming to the
specifications.
An error occurred in the transmitted print
data.
An error occurred in the communication
of USB.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of
the X motor was detected.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error due to an excessive current of
the Y motor was detected.
Message Cause Solution
To Next Page
Loading...
