Safety Precautions
vii
Precautions in Use
Hazardous Moving Parts
• Keep Fingers and Other Body Parts Away
• If a foreign object such as a small piece of metal or
a liquid such as water gets inside the machine, turn
off the machine and unplug the power cord
immediately, then consult your service
representative. Continuing to use the machine
without proper maintenance or repair may result in
fire or electric shocks.
• Do not use a flammable spray or solvent inside or
around the machine. Doing so may result in fire or
electric shocks.
• Do not place a vase, flower pot, water glass,
container with liquid such as water or chemicals
inside, or small metallic object near or on top of this
machine. Liquid or foreign object may get inside the
machine, leading to fire or electric shocks.
WARNING
CAUTION
Handling of the power cable
• Connect to a socket-outlet with determinate polarity.
• For Inlet, be sure to supply power from the outlet of
the same voltage.
• for PLUGGABLE EQUIPMENT, the socket-outlet
shall be installed near the equipment and shall be
easily accessible.
• Unplug the cord from the wall outlet and remove
dust from the power plug periodically, at least once
a year. Failure to do so may result in fire or electric
shocks.
• Do not use the machine unless it is connected to a
power supply that satisfies the displayed voltage
condition.
• Check the voltage of the wall outlet and the
capacity of the circuit breaker before you plug the
power cords. Plug each power cord to different
outlet that has independent circuit breaker. If you
plug more than one power cord to wall outlets that
share the same circuit breaker, the power may be
cut off by the breaker.
Power supply
• Leave the breaker turned ON.
• Do not turn off the main power switch on the right
side of this machine.
Heater
• Do not spill liquid on the Media Transfer
Surface as this may cause failure of the heater
or firing.
• Do not touch Media Transfer Surface heaters
with bare hand while it is hot; otherwise, you
can get burned.
Note on maintenance
• When cleaning the ink-station or the heads, make
sure to wear the attached goggles and gloves.
• The gloves supplied with the machine are
disposable. When all the gloves are expended,
purchase an equivalent product on the market.
• Do not to touch the sharp edge of the blade when
replacing the cutter. Touching the sharp edge may
result in injury.
• Turn off the machine and unplug the power cord
from the wall outlet for safety when moving the
machine.
Handling of ink
To Next Page
Loading...
