MIMAKI JV150-130 - Printing Check Flow; Printing Operations at Nozzle Missing Judgment and Error Occurrence

3-21
1
2
3
4
5
6
Chapter 3 Nozzle Check
Printing Check Flow
Nozzle check is conducted according to the following flow at the start of printing.
Printing Operations at “Nozzle Missing” Judgment and Error Occurrence
 When judged to be “Nozzle Missing”  Printing is stopped.
 When error occurs during nozzle check  Printing is stopped and “Printing Check” is automatically
turned OFF. After recovering from the error, set “Printing
Check” once again.
• Turn the “Printing Check” setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check  Judgment
2
3
Recovery operation 
nozzle check  Judgment
4
Retry  Judgment
Printing Check  Judgment
Detects missing nozzles.
If more missing nozzles than “Judgement
Condition ” are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
5
Nozzle Missing judgment
If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
If more missing nozzles than “Judgement
Condition ” are detected after the recovery
operation, the recovery operation is conducted
again.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the “Printing Check” setting ON to be enabled.