MIMAKI JV150-130 - Page 33

2-7
2
2
2
5
6
Chapter 2 Basic Operation
12
Set an empty core of the roll media on the
take-up device.
13
Close the front cover.
14
Press the key to select “ROLL” .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance
function is “ON” ( P.3-12), the screen for
entering media remaining amount is displayed
after detecting the media width.( P.2-7)
15
Secure the media on the take-up device.
(P.2-8)
(1) Feed the media up to the core of the roll
media of the take-up device by pressing the
[] key.
(2) Fix the middle of the media with adhesive
tape.
(3) In the same manner, fix the left side and right
side of the media.
• Make sure that the there is no slack or
wrinkle on the media in such condition that
the roll media is pulled to right and left evenly,
and then stick the tape.
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is
“ON” (
P.3-12), the screen for entering media
remaining amount is displayed after detecting the media
width.
1
Display the screen for entering media
remaining amount.
2
Press to enter the media
remaining amount.
3
Press the key.
About the media residual print
When [MEDIA RESIDUAL] of the maintenance function is
“ON” ( P.3-12), You can print a list of print the current
date and media remaining.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press the key.
• Appear the confirmation screen of media
remaining print.
3
Press the key.
• Media residual print starts.
Core
Take-up
device
Front cover