4-10
Chapter 4 Maintenance
6
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
7
Press the key.
8
Fill up the cap with cleaning solution for
maintenance．
• If the cleaning solution cartridge is not usable,
suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
9
Close the front cover and press the
key.
10
Press to set the time for the
cleaning solution to be left as it is.
• Set Value:1 to 99 min (by the unit of 1 min)
11
Press the key.
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves to the maintenance position.
12
Open the front cover.
13
Fill up the cap with cleaning solution for
maintenance．
• If the cleaning solution cartridge is usable,
maintenance solution is automatically filled. If there
is not enough maintenance solution, press the
[FUNCTION] key to add maintenance solution.
• If the cleaning solution cartridge is not usable,
suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
14
Close the front cover and press the
key.
• After its initial operation, the machine returns to
step2.
• Until washing liquid is filled, [COMPLETED
(NEXT): ENT] is displayed on the screen. After the
work up to the Step 8 is completed and you close
the front cover, press the [ENTER] key. If you
press the [ENTER] key before washing liquid is
filled, the carriage returns to the original position.
To Next Page
Loading...
