Overhaul of Driving Parts
3-37
8
Move the head unit over the platen, and remove the head cover (2 screws) and station cover
(2 screws) (See P. 3 - 4 )
9
Remove the slider rear panel screw (x1),
and remove the height lever base assem-
bly.
10
Remove the slider rear panel screws
(x2), and detach the head unit from the
Y-axis drive belt.
11
Slide out the connection point of the Y-
axis drive belt, and remove either the
left or right belt holder 1 from the belt
holder.
* Do not remove the Y-axis drive belt from the
slider.
12
Remove the screw (x1), and detach the
DBKT U from the Y-axis drive pulley.
Height level
base assembly
Insert a screwdriver into the gap in the
damper and remove the damper
Insert a screwdriver into the gap in the
damper and remove the damper
Belt holder(M400161)
Belt holder 1
Do not remove the screw
To Next Page
Loading...
