MIMAKI UJV100-160 - Register the Ink IC chip

Chapter 1 Before Using This Product
43
Ink set Ink layout
1 2 3 4 5 6 7 8
4-color M C Y K M C Y K
4-color, W M C Y K - - W W
4-color, W, CL M C Y K CL CL W W
1
Mount ink bottles in the tank.
• Rotate the lever on the tank section from the left to the right end, then mount the ink bottle.
Lever
2
Turn the tank lever from right to left to secure the bottle.
• Never attempt to rotate the ink bottles. Doing so may result in leaking ink.
• Once the ink bottle is mounted, use up the ink as quickly as possible.
l
Register the Ink IC chip
Printing is not possible unless the ink IC chip has been registered.
• Do not touch the metal parts of the ink IC chip. Dirt or damage may prevent data transfers or
result in damage to the ink IC chip due to static electricity.
• Insert the ink IC chip with the metal side facing up. Inserting it in the wrong way may cause
failure or damage to the ink IC chip.
1
Switch to LOCAL mode.
• Chip registration is possible only in LOCAL mode.
2
Insert a new ink IC chip into the ink IC chip slot on the right-hand side of the product.
• A registration screen appears when the ink IC chip is inserted.
• When replacing two Ink bottle with the same color at the same time, select the slot
number to be registered. Be careful to avoid registering a wrong slot number.
1