Chapter 2 Printing
54
2
Move the rear left roll holder to the roll setting position.
• Unscrew the roll holder retaining screw before moving.
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
R ol l Ho l d er
S et P os i t io n
3 I n c h R o ll M ed i a
2 I n c h R o ll M ed i a
Mount the roll holder so that the datum position is
within this range.
Roll media paper cores are one of two diameters: 2 inches or
3 inches.
3-inch core mounting position
2-inch core mounting position
Reference
3
Tighten the retaining screw on the rear left roll holder.
4
Place roll media on the roll media hanger.
5
Attach the core of the roll medium to the rear left roll holder.
• Push until the core moves no farther.
6
Insert the rear right roll holder into the core.
• Unscrew the roll holder retaining screw before moving.
7
Tighten the retaining screw on the rear right roll holder.
8
Insert the medium.
• Insert into the gap between the pinch roller and the grit roller.
• Inserting media at an angle allows smooth insertion without catching or sticking.
To Next Page
Loading...
