Chapter 2 Printing
55
9
Lower the clamp lever.
• Hold the media with the pinch roller and grid roller.
10
Move to the front of the machine and open the front cover.
11
Raise the clamp lever and pull out the medium.
• Make sure the medium does not fall to the rear.
• Adjust the rear roll holder position so that the medium does not cover the right-hand slit
line on the platen. Movement at an angle may result in damage to the print head.
Slit line
Media
Media holder
• The areas extending 5 mm from both sides of the media are margins.
12
Gently pull out the medium and stop at the position where it is gently locked in place.
13
Check how far the medium was pulled out.
• Pull the front edge of the medium gently at several points to confirm that the medium was pulled
out by the same amount.
2
To Next Page
Loading...
