Mindray DC-40 User Manual

Patient Data Management 10-17
(2) Select the user name in the drop-down list of User Name.
(3) Enter password and click [Login].
 To change user:
(1) To log out the current user and change to another user, click
at the lower right
corner of the screen to pop up the following dialogue box:
(2) Click [Change User] to pop up the Login dialogue box.
(3) Enter the user name and password in the field box.
NOTE: You have to exit the Preset screen before changing the user.
10.9.4 Adding/Deleting a User
The system administrator can add and delete a user, while the operator can’t.
Add a User
Premise: you must log on the system as the system administrator. If not, you will be
required to enter administrator name and password before the setting.
1. Open the “Admin” page through the path: [Setup]Æ[System Preset]Æ[Admin].
2. Click [Add] to pop up the following dialogue box.
3. Enter user name.
4. Enter the password and the confirmed password.
5. Set the user role in the drop-down list: administrator or operator.

Mindray DC-40 Specifications

General

Touch Screen	Yes
Hard Drive	500 GB
3D/4D Imaging	Yes
Storage Temperature	-20°C to +60°C
Operating Temperature	+10°C to +40°C
Atmospheric Pressure	700 hPa to 1060 hPa
Imaging Modes	B, M, Color Doppler, Power Doppler
Probes	Convex, Linear, Phased Array
Connectivity	DICOM, USB, Ethernet
Power Supply	100-240V AC, 50/60Hz
Display	15-inch color LCD