Care and Maintenance 12-5
One dust-proof mesh on the left of the system: put the mesh into the slot of the electronic
assembly. Push the dust-proof mesh backwards until the mesh snaps into the slot, and
then close the door of the electronic assembly.
The dust-proof cover of the probe socket: plug the probe properly.
Please clean all dust-proof covers of the system periodically (once per
month); otherwise, it may result in damage. Cleaning times can be
increased when the system is used in the open air or somewhere dust is
more.
2. Monitor cleaning (touch screen)
â—¼ Tool: dry soft cloth, clean water and soap-suds.
â—¼ Method:
Use dry clean soft cloth to clean monitor and touch screen. If there are any stains, use dry soft cloth
or mild soap-suds to clean to clean off. Then, air dry it.
3. Trackball cleaning
â—¼ Tool: tissue, dry soft cloth, mild soap-suds
âš« Disassembling the trackball:
Press the bulges on the clamping ring by both hands and turn the ring about 35°
counterclockwise until it lifts. Take out the ring and the rotary ball. Be careful not to drop the ball.
As shown below：
âš« Cleaning:
Clean the two long shafts, the bearing, plastic cover and the internal area of clamping ring (see
the illustration below) with clean soft dry cloth or tissue.
To Next Page
Loading...
Need help?
General
