Minebea Intec PR 5310 - Page 97

6. Operating | 6.2 - Configuration and adjustment via the keypad | 97
IF · Information
– 090SoFt.VE
Software version
– 091SLot
EMPty Empty or PR 5310 card type
– 092rS-232
Protocol assigned to the RS232 interface
– 093rS-485
Protocol assigned to the RS485 interface
– 094Rtc.bat
Battery status of the RTC battery at low voltage bAT ok/bAT not.ok OK/not
OK
FS · Factory reset
– 100rESEt.?
Reset all configuration parameters and calibration data to default values?
no No
yES Yes
PP · Print device configuration
– 110Print?
Print all configuration parameters? This is only possible if a printer has
been assigned.
Note:
The meanings of the specific data and parameters and the associated val
ue ranges are explained in the corresponding chapters.