Minebea Intec PR 5310 - Page 96

6. Operating | 6.2 - Configuration and adjustment via the keypad | 96
SI · Serial ports parameter
– 070PrInt
Printer: Configuring the interface, see Chapter Configuring the serial
interface for the printer
– 071rEMdSP
Remote display: Configuring the interface, see Chapter Configuring the
serial interface for the remote display
– 072SMA
SMA: Configuring the interface, see Chapter Configuring the serial interface
for SMA
– 073ModbuS
ModBus-RTU: Configuring the interface, see Chapter Configuring the serial
interface for ModBus-RTU
FP · Fieldbus parameters
– 080FLd.Pro
Protocol of the installed field bus card
PdP-U1 ProfiBus-DP
dEV.nEt DeviceNet
dEUnEt EtherNet/IP
PronEt ProfiNet I/O
– 081PdP.Adr
ProfiBus: PDP address
– 082dVnbdr
DeviceNet: Baud rate
– 083dVnAdr
DeviceNet: Address
– 084dHCP
DHCP (On/Off)
– 085IP-Adr
IP address
– 086SubnEt
Subnet mask