Mircom QX-mini Programming Guide

58
SLC Integration - QX-mini and FX-3500 - Single Stage
11. Click on panel inputs, click on the ‘+’ sign. Select Panel input address to activate EVAC
zone. Ensure this address corresponds to “supervised output module” in Figure 81.
Figure 85 SLC/RELAY-IN/SYNC Correlations
12. All the correlations in job file can be viewed in “Report” as shown below.
Figure 86 Report
13. Save the job, connect to QX-mini Master and send the job.
14. After job has been successfully sent to the panel, disconnect the USB connector.

Mircom QX-mini Specifications

General

Brand	Mircom
Model	QX-mini
Category	Security System
Language	English