17
3.0 Firmware Upgrade
Note: Firmware upgrade must be performed to both the Master and Booster
units individually.
1. Open the MGC Emergency Communication Systems (ECS) configurator.
2. Connect to the panel and then click “Firmware Upgrade”
Figure 23 Firmware Upgrade
3. Choose the latest firmware from the list and click “upgrade”. If firmware file is saved on
the computer, click on “Custom Firmware” and then click “Upgrade”. Select the
appropriate file.
Figure 24 List of firmwares
Note: Upgrade process takes approximately 1 minute. Wait for the following
window before disconnecting.
To Next Page
Loading...
