To Next Page

To Previous Page

SLC Integration - QX-mini and FX-2000 - Two Stage

10.4 SLC Address Configuration

• Alarm Input: In Figure 102 on page 69, Input Module address 101 is an example of any

alarm input in the job. It would need to be correlated to Supervised Output module

addresses to activate alert stage.

• Common Trouble: This feature allows the QX-mini to report any trouble(s) back to the

FACP. Referring to Figure 102, address 103 is an example of trouble input. Configure the

type as “trouble input” in the FACP configurator.

• Signal Silence: This feature allows FACP to silence audible and visible devices on the

QX-mini.

• Audible and Visual signal silence: Configure this as a relay output module, address

101 (shown in Figure 102), and correlate it to “signal silence” common status in the

FACP configurator.

• Paging/Message Active: This feature reports to FACP when QX-mini has been

manually activated. For example, when microphone is active or a message has been

activated, trouble will report back to FACP. Configure this as an input module (Address

101 in Figure 102) in the FACP configurator, and select type as “building/property

safety”.

• AC Trouble: This feature reports QX-mini AC failure to FACP. If QX-mini is configured

for “AC Loss Delay” then a trouble will only be reported after the delay. Configure this as

an input module (Address 106 in Figure 102), and select type as “trouble input” in the

FACP configurator.

• Battery/Charger Trouble: This feature reports to FACP when QX-mini has a battery or

battery charger trouble. Configure this as an input module (Address 107 in Figure 102),

and select type as “trouble input” in the FACP configurator as shown in Figure 102.

• Earth Ground Fault: This feature reports to FACP when there is a ground fault detected

on QX-mini system. Configure this as an input module (Address 107 in Figure 102) and

select type as “trouble input” in the FACP configurator.

18. Ensure all the addresses are correct and job is validated. Connect to the FX-2000 panel

and send the job.

Mircom QX-mini Programming Guide

Other manuals for Mircom QX-mini