Mitsubishi Electric EZMOTION MR-E Super MR-E-70A-QW003 - Page 101

5 - 16
5. PARAMETERS
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
44 *DI3 Input signal selection 3 (CN1-3)
Allows any input signal to be assigned to CN1-pin 3.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Position
control mode
Input signals of
CN1-pin 3
selected.
Internal speed
control mode
0
0
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 3.
This parameter is unavailable when parameter No.48 is set to assign the
Forward rotation stroke end (LSP) and Reverse rotation stroke end (LSN) to
be assigned to CN1-pin 3.
0882 Refer to
name
and
function
column.
P
S
45 *DI4
Input signal selection 4 (CN1-5)
Allows any input signal to be assigned to CN1-pin 5.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Position
control mode
Input signals of
CN1-pin 5
selected.
Internal speed
control mode
0
9
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 5.
This parameter is unavailable when parameter No.48 is set to assign the
Forward rotation stroke end (LSP) and Reverse rotation stroke end (LSN) to
be assigned to CN1-pin 5
0995 Refer to
name
and
function
column.
P
S
Expansion parameters 1
46 *DI5
Input signal selection 5 (CN1-6)
Allows any input signal to be assigned to CN1-pin 6.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Position
control mode
Input signals of
CN1-pin 6
selected.
Internal speed
control mode
0
0
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 6.
This parameter is unavailable when parameter No.48 is set to assign the
Reverse rotation stroke end (LSN) to be assigned to CN1-pin 6.
0000 Refer to
name
and
function
column.
P
S
www.DataSheet4U.com