5 - 15
5. PARAMETERS
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
Expansion parameters 1
43 *DI2 Input signal selection 2 (CN1-4)
Allows any input signal to be assigned to CN1-pin 4.
Note that the setting digit and assigned signal differ according to the control
mode.
Position
control mode
Input signals of
CN1-pin 4
selected.
Internal speed
control mode
0 0
Signals that may be assigned in each control mode are indicated below by
their symbols.
Setting of any other signal will be invalid.
Set value
(Note) Control mode
PS
0
1
2
3
4
5
6
7
8
9
SON SON
RES RES
PC PC
SP1
SP2
ST1
ST2
CR CR
A
SP3
B
C
D
TL1
E
CDP
CM1
CM2
TL1
CDP
F
Note. P: Position control mode
S: Internal speed control mode
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 4.
This parameter is unavailable when parameter No.48 is set to assign the
Forward rotation stroke end (LSP) and Reverse rotation stroke end (LSN)
to be assigned to CN1-pin 4.
0111 Refer to
name
and
function
column.
P
S
To Next Page
Loading...
