5 - 14
5. PARAMETERS
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
40 For manufacturer setting
Do not change this value by any means.
0
Refer to
name
and
function
column.
P
S 41 *DIA Input signal automatic ON selection
Used to set automatic servo-on (SON)
forward rotation stroke end
(LSP)
reverse rotation stroke end (LSN).
Servo-on (SON) input selection
0: Switched on/off by external input.
1: Switched on automatically in servo
amplifier.
(No need of external wiring)
0: Switched on/off by external input.
1: Switched on automatically in servo
amplifier.
(No need of external wiring)
0: Switched on/off by external input.
1: Switched on automatically in servo
amplifier.
(No need of external wiring)
Reverse rotation stroke end (LSN)
input selection
Forward rotation stroke end (LSP)
input selection
0
0000
PS
42
*DI1 0002 Refer to
name
and
function
column.
P/S
Expansion parameters 1
Input signal selection 1
Used to assign the control mode changing signal input pins and to set the
clear (CR).
Control change (LOP) input pin assignment
Used to set the control mode change signal
input connector pins. Note that this parameter is
made valid when parameter No.0 is set to
select the position/internal speed change mode.
Set value
0
1
2
Connector pin No.
CN1-4
CN1-3
CN1-5
3 CN1-6
Clear (CR) selection
0: Droop pulses are cleared on the leading edge.
1: While turning on, droop pulses are always
cleared.
4 CN1-7
0 0
If forward rotation stroke end (LSP) or reverse
rotation stroke end (LSN) is assigned to any pin
with parameter No.48, this setting is invalid.
P
To Next Page
Loading...
