13 - 16
13. OPTIONS AND AUXILIARY EQUIPMENT
3) When fabricating the encoder cable
When fabricating the cable, prepare the following parts and tool, and fabricate it according to the
wiring diagram in 2). Refer to section 13.2.1 for the specifications of the used cable.
Parts/tool Description
Connector set MR-ECNM
Servo amplifier side connector
Receptacle: 36210-0100PL
Shell kit: 536310-3200-008
(3M)
Or
Connector set: 54599-1019
(Molex)
Encoder side connector
Housing: 1-172161-9
Connector pin: 170359-1
(Tyco Electronics or equivalent)
Cable clamp: MTI-0002
(Toa Electric Industries)
(c) MR-J3JCBL03M-A1-L
MR-J3JCBL03M-A2-L
The servo amplifier and servo motor cannot be connected with these cables only. The servo motor side
encoder cable (MR-EKCBL
M-L/H) is required.
Cable model Cable length
Protective
structure
Flex life Application
MR-J3JCBL03M-A1-L For HF-KE W1-S100 servo motor
Load side lead
Use in combination with MR-EKCBL
M-L/H.
MR-J3JCBL03M-A2-L
0.3m IP20 Standard
For HF-KE W1-S100 servo motor
Opposite-to-load side lead
Use in combination with MR-EKCBL
M-L/H.
To Next Page
Loading...
