Mitsubishi Electric EZMOTION MR-E Super MR-E-70A-QW003 - Page 306

15 - 47
15. MR-E- AG-QW003 SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
44 *DI3 Input signal selection 3 (CN1-3)
Allows any input signal to be assigned to CN1-pin 3.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Speed
control mode
Input signals of
CN1-pin 3
selected.
Torque
control mode
0
2
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 3.
If forward rotation stroke end (LSP) or reverse rotation stroke end (LSN) is
assigned to pin 3 of CN1 with parameter No.48, this parameter cannot be
used.
0882 Refer to
name
and
function
column.
S
T
45 *DI4
Input signal selection 4 (CN1-5)
Allows any input signal to be assigned to CN1-pin 5.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Speed
control mode
Input signals of
CN1-pin 5
selected.
Torque
control mode
0
5
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 5.
If forward stroke end (LSP) or reverse rotation stroke end (LSN) is
assigned to pin 5 of CN1 with parameter No.48, this parameter cannot be
used.
0995 Refer to
name
and
function
column.
S
T
Expansion parameters 1
46 *DI5
Input signal selection 5 (CN1-6)
Allows any input signal to be assigned to CN1-pin 6.
The assignable signals and setting method are the same as in input signal
selection 2 (parameter No.43).
Speed
control mode
Input signals of
CN1-pin 6
selected.
Torque
control mode
0
0
This parameter is unavailable when parameter No.42 is set to assign the
control change (LOP) to CN1-pin 6.
If reverse rotation stroke end (LSN) is assigned to pin 6 of CN1 with
p
arameter No.48, this
p
arameter cannot be used.
0000 Refer to
name
and
function
column.
S
T
www.DataSheet4U.com