3 MELFA Smart Plus card
Installing/removing and setting of the MELFA Smart Plus card 3-7
3.2.1.1. Installing of the MELFA Smart Plus card
Here is the procedure for installing the MELFA Smart Plus card/card pack.
Figure 3-1 Installation of MELFA Smart Plus card/card pack
1) Turn off the controller.
2) Grasp the interface cover removal lever lightly and pull out the interface cover.
3) Hold the handle of the MELFA Smart Plus card and insert it into SLOT 1 or SLOT 2.
At this time, please insert so that both ends of the card fit into the slots of the slot (SLOT 1 and SLOT 2
in Figure 3-1).
4) Insert the connector firmly until it is firmly locked until the release lever clicks.
Installation of the MELFA Smart Plus card is now complete.
or
MELFA Smart Plus card puck
To Next Page
Loading...
