What to do if I see ‘Cannot be used (base coop)’ error because of interference avoidance function on Mitsubishi Electric Robotics?
If you're seeing the error 'Cannot be used (base coop)' on your Mitsubishi Electric Robotics, it's likely because the interference avoidance function is currently active. To fix this, invalidate the interference avoidance function.
Why does my Mitsubishi Electric Controller show a CC-Link cable error?
A CC-Link cable error on your Mitsubishi Electric Controller indicates that either the cable is not properly connected or the parameters do not match. To resolve this, reset the power and start the system again.
How to fix CC-Link initialization error on Mitsubishi Electric Controller?
A CC-Link initialization error on your Mitsubishi Electric Controller occurs when the master station's parameters do not match. Correct the parameters, and then restart the system.
What happens if a CC-Link register number is outside the range on Mitsubishi Electric Controller?
If a CC-Link register number is outside the allowable range on your Mitsubishi Electric Controller, it means that the entered register number is incorrect. Enter the correct value to resolve this.
What to do if two CC-Link interface cards are mounted on Mitsubishi Electric Controller?
If two CC-Link interface cards are mounted on your Mitsubishi Electric Controller, mount one card in slot 2. It is not allowed to install two cards, so install only one card.
Why can't I set a CC-Link master station on my Mitsubishi Electric Controller?
If you cannot set a CC-Link master station on your Mitsubishi Electric Controller, it is because a master station is already set by the rotary switch. Set the rotary switch to a setting other than 0.
Why interpolation cannot be executed on Mitsubishi Electric MELFA CR800-D?
If your Mitsubishi Electric Robotics system displays the message 'Interpolation cannot be executed', it's because an addition axis is going to move. Please do not move an addition axis.
What to do if I see ‘Illegal unit system (axis tracking)’ error on Mitsubishi Electric MELFA CR800-D Robotics?
If you encounter the 'Illegal unit system (axis tracking)' error in your Mitsubishi Electric Robotics system, it means a rotary axis has been designated. Designate a linear drive axis instead.
What to do if I see ‘Cannot be used (axis tracking)’ error on Mitsubishi Electric MELFA CR800-D Robotics?
If you're seeing the error 'Cannot be used (axis tracking)' on your Mitsubishi Electric Robotics, it's likely because a synchronous addition axis control is effective. To fix this, invalidate a synchronous addition axis control.
What to do if work setting cannot be changed in Mitsubishi Electric Robotics?
If you are getting the error 'Work setting cannot be changed' on your Mitsubishi Electric Robotics, it's because the work coop is currently executing. To change the work setting, you need to invalidate the axis tracking first.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MELFA CR800-D Series |
| Category | Robotics |
| Language | English |
To Next Page
