Mitsubishi Electric MELFA CR800-D Series - Items to be Checked before Using this Product; Checking the Product; Devices to be Furnished by the Customer

13
4. Items to Be Checked Before Using This Product
4.1. Checking the Product
The product you purchased consists of the following items as standard. Please verify that the package
contains all the items.
Table 4.1-1 List of the Standard Items in the Package
No.
Note)
Name
Type
Quantity
①
Instruction Manual (CD-ROM)
BFP-A8615
1
②
CC-Link interface card TZ576 1
③
Ferrite core
E04SR301334
2
④
On-line connector for communication
A6CON-LJ5P
1
⑤
Terminator
A6CON-TR11N
1
⑥
One-touch connector plug for
communication
A6CON-L5P
2
⑦
Cable clamp
AL5
2
⑧
Cable clamp
AL4
2
Note) The number of the table is equivalent to the number of following figure.
Figure 4.1-1 Items Contained in the Package
4.2. Devices to Be Furnished by the Customer
When using Mitsubishi Electric CC-Link interface card, the devices listed in Table 4.2 below must be
furnished by the customer.
Table 4.2-1 Equipment prepared of the customer
Device to be furnished
Condition
Master station
The master station corresponding to the intelligent device station
Communication cable
*1）
The cable only for CC-Link
Performance of the CC-Link system cannot be guaranteed except the
cable only for CC-Link.
The maximum cable total extension and the cable length for the station
have restriction.
Note) If extended cyclic setting is set up more than double, transmission delay time
will become long. Refer to the instruction manual of CC-Link for details.
*1) For details, refer to "the cc-Link association (http://www.cc-link.org/)."
②
③
①
④
⑤ ⑥ ⑦ ⑧
[AL4]
D=6.4mm
[AL5]
D=9.6mm