1.2. General name and abbreviated name
Table 1.2-1 General name and abbreviated name
General / abbreviated name Details
Remote input and output, a transmission means to
communicate the details of the remote register periodically
A transmission method to specify the partner to any timing
and to communicate by 1:1
The station which controls the data link system
The one station is required for the one system.
The station for backup which succeeds data link control when
the master disconnected data link faulty by the abnormalities,
such as sequencer CPU and the power supply
The station which has sequencer CPU and can communicate
with the master station and other local stations
The station only treating the information on the bit unit
The station treating the information on the bit unit, and the
information on the word unit
Intelligent device station
The station treating the information on the bit unit, and the
information on the word unit, and also the transient
Special mode which transmits and receives the data at the
remote I/O station and the high speed
The mode which can communicate with all the stations for
CC-Link
（link special relay）
Information on the bit unit which shows the operating state and
data link state of the unit of the master station and the local
（link special register）
Information on the 16-bit unit which shows the operating state
and data link state of the unit of the master station and the
（
）
Information inputted by bit unit into the master station from the
slave station
（
）
Information outputted by bit unit into the master station from
the slave station
（remote register for the writing）
Information outputted to the remote device station, the local
station, and the intelligent device station from the master
（remote register for reading）
Information inputted to the remote device station, the local
station, and the intelligent device station from the master
To Next Page
Loading...
