Mitsubishi Electric MELFA CR800-D Series - Connection of CC-Link Master-Station Unit and Cable Only for CC-Link

22
6.2.2. Connection of CC-Link master-station unit and cable only for CC-Link
The connection method of the CC-Link master-station unit prepared by the customer and the CC-Link
cable is shown in the following.
(1) Stick another side of the CC-Link cable by pressure.
(2) Connect the shield line to the SLD terminal in the terminal of the master-station unit. Refer to the
lower right figure
(3) Connect the electric wire to DA, DB and DG in the terminal of the master-station unit.
(4) Connect the terminal to the master-station unit.
・・・・・